Other Network Architecture Subjects

How to edit access list order (in the same access list number)? Do I need to delete the whole access list and re-add them one by one in order that I want? I knew that name access list can be assigned the order number. Can convention access list do th...

From "show ip route" command, "S* 0.0.0.0 [1/0] via 172.19.2.2", what is asterisk mean?

Does command "ip subnet-zero" included the last subnet (all ones) too? Or just all zeros?

What is the different between dynamic / static vlan types? "(config-if) #vlan-membership dynamic | static"

When happen when "Serial0 is down, line protocol is up" and "Serial 0 is administratively down, line protocol is up"? Are they a possible status?

OSPF, RIP V.1, RIP V.2, IGRP only support IP protocol? And EIGRP is the only routing protocol that supports IP, IPX, and AppleTalk. Right?

"Router (config) #bandwidth <value>" This command set bandwidth value for an interface. Is this correct command? Should this issue in interface config mode or global mode? Can bandwidth command use to limit the bandwidth of an interface? What is the ...

"PAR-Provides reliability by requiring that the recipient acknowledges receipt of a group of segment before a timer expires" What is PAR stands for? What layer or protocol it is in? Is this always run?

RxBoot vs. ROMMON. Are they the same? What are they for?

In link state routing protocols, full update that happen every 30 minutes, does the routers exchange the whole routing table with each other? Or exchange something else, not full routing table. If not the whole routing table, what they are exchanged?

"show arp" in router vs. "show mac-addreass-table" in switch? Are they the same?1.2

How switch password level work? How to confiugre?1.1

In serial connection, does it required to have DCE at one end AND DTE on the other end? Because Boson Network Simulator serial interface can work even both ends are DTE, that makes me confused.

"The link state method is not susceptible to routing loops which is an advantage over the distance vector method" Why? How it avoid routing loop?

VLSM vs. CIDR? How they are different or related?