Other Network Architecture Subjects

Hi, I would like to create 2 user groups (A & B) in my ACS server such that Users in A group are able to access switches and routers only where as Users in B group are able to access only MGXs. Group A users should nt access MGX and Group B users are...

Hi All,To assign an IP address to the management VLAN (default is VLAN 1)Cmd are:Switch(config)# interface vlan vlan-idSwitch(config-if)# ip address ip-address netmaskSwitch(config-if)# ip default-gateway ip-addressSwitch(config-if)# no shutdown1.I c...

We have a customer who has their edge switch connected to two core switches, between the two core switches we have configured an Etherchannel. We have used Spanning Tree to block at the edge, therefore one core switch is the root for even vlans and t...

HiI have to install a new version on a AP and i just downloaded a .tar file from Cisco.My question is, can i boot directly from that tar file?I never tryied this and before doing something wrong i want to be sure it will work. I read somewhere that m...

I am trying to set up a voice and data vlan, each with a seperate IP range. The default VLAN (1) is the data Vlan, but when I enter an IP address under the voice Vlan, the primary Vlan shuts down.Is it possible to have two IP addresses on a 2950? If ...

Hi All, I have a Cisco 2610 Router having IOS version 12.2(29a). I want to run isis protocol on this router but unable to do this. When I enter " router isis " command in configuration mode then the prompt does not change to Router(config-router)# mo...

Can some one give Links relted to STP and RSTP where i could learn from the study documents

Hello Friends,I have Six Catalyst 2955 Switches on which RSTP is running (Just "spanning-tree mode rapid-pvst" runs)...now I want to ask what are the other standard things (like IGMP snooping etc) needed to configure switches to improve performance (...

hi I need to rate limit the traffic on each port I've also tried policing but when its applied to the specific interface using "service-policy output xxxx", i get the error "Warning: Assigning a policy map to the output side of an interface not suppo...

WS-C6506 Software, Version NmpSW: 6.1(1b)Copyright (c) 1995-2000 by Cisco SystemsNMP S/W compiled on Nov 9 2000, 22:11:25System Bootstrap Version: 5.3(1)Hardware Version: 3.0 Model: WS-C6506 Serial #: TBA05061441Mod Port Model ...

I have three three routers connected in a straight line. For sake of simplicity I'll call them my left, --Left---eth----Middle--serial---Right-- Left runs only RIPv2, Middle runs OSPF and RIPv2 and mutually redistributes bewteen the two, and Right r...

Hi,i could able to ping 10.2.1.0 & ofcourse broadcast can ping 10.2.1.255. so is it normal r something probz went wrong like looping?

Hi,Newbie here... 2 questions:1. Say you do "sh access-list 109", and see something like this:..permit tcp any any established..permit udp any any eq bootps (116125 matches)..permit icmp any any (782 matches)..permit udp 10.0.0.0 0.255.255.255 10.0....