Other Network Architecture Subjects

Anyone know how i can get this version or greater?

Note: The "not found" are actual vlan IPs and "found" are standby(virtual) IPs.1w1d: HSRP: Vl2 API active virtual address 10.18.88.220 not found1w1d: HSRP: Vl2 API active virtual address 10.18.88.222 found1w1d: HSRP: Vl2 API active virtual address 10...

'Switch uptime' of one switch in 3750 stack shows a fixed value and never change. 'Switch uptime' on other switches in same stack works fine. Anybody knows why?S.K.

I have just been reading the cisco white pages on ospf, it says ospf doesnt form neighbour adjacencies with routers on another subnet ? how can this be true ? I have multiple subnets on my site all on etherent and they can all see each other !!

HI all,This router (7304) has a flash memory and disk0 devices, the thing is that if you don´t specify the boot system lines in the config it starts with the first image stored in the disk0 device, by the way, there are disk0 and stby-disk0 devices b...

I am working with TAC on this issue, but I thought I might get some input from the community at large.I have two CAT6509's running Native IOS. I have setup HSRP on these switches in the standard way. I am having Unicast traffic flooding on random p...

can anyone give me an example of a discontinous network, is it basically different subnets ? if all my routers were in the same subnet would it be continous ?thanks

Dear Netpro.I've 2 vlans which is VLAN 10 and VLAN 20.VLAN 10 (10.10.10.1)and VLAN 20 (20.20.20.1). From Vlan 10 i can ping to Vlan 20, but from Vlan 20 cant ping to Vlan 10. routing is all routed. does anyone got any idea ?Regards,Jack

Rather odd problem...Our network is all Static IP's in the 10.10.xx.xx range. The other day a problem was arrising with one of our domains. When pinging MNBlah domain, we'd get replies from some 169.254. address (i forget last 2 octects). I'm no M...

Hi We are seeing a lot of overruns on most of cat6 ge ports. switch1 tapps026 2 input errors 0 CRC 0 frame 91 overrun 0 ignoredswitch1 w2k3edmwt02 2 input errors 0 CRC 0 frame 90 overrun 0 ignoredswitch2 W3BSSMDPD0 4 input errors 0 CRC 0 frame 182 ov...

With route maps, are these just used inconjunction with other things like, pbr, are they just the template in effect ?

HOW WOULD I GET EIGRP TO ADVERTISE A DEFAULT ROUTE, ALSO I HAVE SEEN A COMMAND ON MY ROUTER THAT SAYS REDISTRIBUTE STATIC METRIC 5, CAN ANYONE TELL ME WHAT THE METRIC IS USE FOR IN THIS CASE AND WHAT VALUES IT GOES TO ?THANKS

when subnetting addresses can you use the actual address range where the mask is, what im saying is say that you have a 255.255.255.240 mask, could the addresses from network 225 to 238 be used, I was told that the network that includes the address t...