I would like to know how to configure an Active Passive failover solution using BGP + HSRP(with ip sla to track line up/down) in 2x Cisco CPE. For example the IP assignment as below: Primary Router:- WAN IP: 10.10.10.2/30; GW: 10.10.10.1/30 LAN IP(Primary): 172.16.1.1/24 LAN IP(Secondary): 18.104.22.168/24 HSRP Virtual IP: 172.16.1.3
Backup Router:- WAN IP: 10.10.10.6/30; GW: 10.10.10.5/30 LAN IP(Primary): 172.16.1.2/24 LAN IP(Secondary): 22.214.171.124/24 HSRP Virtual IP: 172.16.1.3
BGP info: AS No: 12345 Remote-AS: 67890 Password: abcde
There will be an unmanaged switch connect to these 2 routers LAN interface and my PC will connect to this switch to perform failover test.
Appreciate if anyone can share his/her knowledge and guide me on this. Let me know if the details above is insufficient.
I have a pair of 3945 routers that are proving to be underpowered for the 100+ remote offices connecting to them. Fortunately I happen to have a couple of 4351 ISRs rated for significantly greater encrypted throughput. Is there any way I could upgrade the...
This article assumes you have the basic knowledge and experience with Cisco DNA Center and Identity Services Engine (ISE).Note when reading this doc the "Authentication Policy" referred to is part of Cisco DNA Center Onboarding section and ha...
Hi, The switch Cisco 2960CX-8PC-L supports PoE+, the total power budget is 124W, which means maximum 4 ports can support PoE+. Let's say the switch now has 2 PoE+ devices connected, does it mean the switch's PoE budget become 64W? Can we use th...
Membership in the Cisco Customer Connection program is required to attend. Registration is free and easy to complete. During registration, choose the Networking track. Once your membership is approved, you'll be able to register for this...