Hi Guys.
I have two QSIG Links to the Third Party PBX. Thus 2 * separate 30 Channel Links between the PBX. I want to group both the 30 Channel, in the dial peer when dialing out to the Third Party PBX. But the dial peer only allows one Port.
Note - We don't have CUCM in our environment. Cisco Router is just used as the Voice Gateway.
Current Configuration is:
dial-peer voice 100 pots
description Calls to PBX
destination-pattern 45.....
port 0/1/0:15
prefix 4
The other QSIG Port is 0/1/1:15
I want the dial peer to use both 0/1/0:15 and 0/1/1:15 to connect calls to the Third Party PBX.
Requesting for your advice on this please.
Regards
Adrian.