C8300 Boot Process

[francisco.j.torres10.ctr]

My C8300 router is in a loop for "hardware initialization..." Unable to break the loop and enter either rommon or startup config.

[balaji.bandi]

post the complete boot process check is there any break process disabled.

this guide explains  more :

https://www.cisco.com/c/en/us/td/docs/routers/cloud_edge/c8300/software_config/cat8300swcfg-xe-17-book/isr9000swcfg-xe-16-12-book_chapter_0111.html

[Leo Laohoo]

Was the router purchased with SD-WAN image?

[Sharktank]

Yes 

[Leo Laohoo]

Raise a TAC Case.

[Sharktank]

Have done that just now .Have you had such a scenario before?

[Leo Laohoo]

---

 wrote:
@Sharktank Have you had such a scenario before?

---

No, but you said "Unable to break the loop and enter either rommon", so there is no other options left except to call TAC.