I have 2 SUP engines (SSO mode) in my Cisco 7609-S routers. Each SUP has 2x10G ports on it. Can I use these onboard 10G port for terminatind the user traffic?
I am checking that if my active SUP switches over then the user connectivity should not be broken as the SUP will now be in Standby state after a reload.
Yes.
Leo, my SUP card is VS-S2T-10G... Will this also support??
in
standby state for control plane like routing, however for forwarding it will continue to forward traffic
Leo, my SUP card is VS-S2T-10G... Will this also suppor
Yes.