05-10-2004 01:29 AM - edited 03-02-2019 03:34 PM
Catalyst 6509 running CatOS 7.6.
"5/4/2004,15:24:25: RxSBIF_SEQ_NUM_ERROR:slot=2, pinnacleMask=0X1, errSeqNum=ff,source Index=0X0, errorType=0X3"
The link above explains the meaning as well as the typical causes of the error. However, it did not
mention the effect of the error once the system is already running. The system seems to be running
well but I would like to know if I still need to try to reseat the module as recommended.
Any help is greatly appreciated.
05-14-2004 02:50 PM
It may seems to be running well but you may have unnoticeable performance degradation etc. So, it's better to re-seat modules as recommended in the document.
05-14-2004 05:28 PM
It is Best to reseat the module as soon as possible...Reseating the module it is talking about 'if' it is only referring to one module should be fine..however, if more than one module is being reported then you will need to reseat _all_ module including the sups as any one module can cause _all_ or many to be reported.
Also, it is not uncommon to see a few of these on re-boot/reload.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: