I picked up a few of the 50 or so WS-C1201 swithces a large California aircraft company retired. They must have done a clear config all to wipe out nvram, but also an erase all to wipe out the ios off of flash. I have the ios to reinstall, but cannot get a prompt to communicate. I have tried shorting jumper J-17, which is supposed to restore a prompt, but cannot get one on any of the switches. Any suggestions?
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...