I have a cisco router configured for dot1q trunking (data vlan + voice vlan) on fastethernet interface. This interface is going to connect to a switchport in the catex500. which role should I assign in the catex500 config? router? switch?
In this same switch I am going to connect a CCM. Once again which role should be assigned to it? ip phone + desktop? other?
Since, you have an external router attached to this switch, it is called "router on a stick" confoguration.
So, your switch will act only as the Switch not the Router.
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: