Help...
I'm trying to set up an= 1921 with Cisco 1921 with EHWIC-4G-LTE-G and I cant get the cellular profile to go active:
Profile 1 = INACTIVE*
--------
PDP Type = IPv4
Access Point Name (APN) = apnname
Authentication = PAP or CHAP
Username: cisco
Password: cisco
I've never set one of these up before so any help would be appreciated.
Extracts from config below:
chat-script lte "" "AT!CALL" TIMEOUT 20 "OK"
!
controller Cellular 0/1
lte sim authenticate 0 xxxx
!
interface Cellular0/1/0
ip address negotiated
encapsulation slip
dialer in-band
dialer pool-member 1
async mode interactive
routing dynamic
!
interface Dialer0
ip address negotiated
ip nat outside
ip virtual-reassembly in
encapsulation slip
dialer pool 1
dialer idle-timeout 0
dialer string lte
dialer persistent
dialer-group 1
!
ip nat inside source list NAT interface Dialer0 overload
ip route 0.0.0.0 0.0.0.0 Dialer0
!
line 0/1/0
script dialer lte
modem InOut
no exec
transport input all
transport output all
I must admit I don't understand how the profile is tied to the cellular interface...