Re: Cisco 7200 IOS installation

rthakker · ‎05-25-2004

Hi Guys,

I am facing problem to upload IOS on Cisco 7200 series router. I rebooted my box but I am keep on getting same output. I am stuck and I don't know what to do can anyone help me how to install IOS on this router.

rommon 1 > ?

alias set and display aliases command

boot boot up an external process

break set/show/clear the breakpoint

confreg configuration register utility

cont continue executing a downloaded image

context display the context of a loaded image

dev list the device table

dir list files in file system

dis disassemble instruction stream

frame print out a selected stack frame

help monitor builtin command help

history monitor command history

meminfo main memory information

repeat repeat a monitor command

reset system reset

set show all monitor variables

stack produce a stack trace

sync write monitor environment to NVRAM

sysret print out info from last system return

unalias unset an alias

unset unset a monitor variable

rommon 2 >

hanxiaolee · ‎05-25-2004

Pls reference :

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml

rthakker · ‎05-25-2004

but I can't see Xmodem command. when I reset this routre getting lots of errors

System Bootstrap, Version 11.1(10) [dschwart 10], RELEASE SOFTWARE (fc1)

C7200 processor with 65536 Kbytes of main memory

an alternate boot helper program is not specified

(monitor variable "BOOTLDR" is not set)

and unable to determine first file in bootflash

loadprog: error - on file open

boot: cannot load "cisco2-C7200"

System Bootstrap, Version 11.1(10) [dschwart 10], RELEASE SOFTWARE (fc1)

C7200 processor with 65536 Kbytes of main memory

device does not contain a valid magic number

boot: cannot open "slot0:"

boot: cannot determine first file name on device "slot0:"

System Bootstrap, Version 11.1(10) [dschwart 10], RELEASE SOFTWARE (fc1)

C7200 processor with 65536 Kbytes of main memory

boot: cannot determine first file name on device "bootflash:"

System Bootstrap, Version 11.1(10) [dschwart 10], RELEASE SOFTWARE (fc1)

C7200 processor with 65536 Kbytes of main memory

Can anyone suggest me ...

Many Thanks

falain · ‎05-25-2004

I guess your boot loader and IOS are corrupted or not the same version.

You have to setup your Bootldr and boot system flash variables in your config in order to point to your flash bootloader and IOS files respectively (prefixed by device name)

put your config register to 0x2102

This can be done via boot rom commands but easier with IOS commands.

Be sure to put your flash cards in the right slot

for ram flash disk use slot0: or slot1:

for ATA flash disk use disk0: or disk1:

Also verify the validity of flash files.

Be sure to transfer in binary mode (in FTP copy)

Compare original and final byte size and checksum

rthakker · ‎05-25-2004

found solution... Document ID: 15082

anyways thanks for your help