Cisco 7204 problems with ESCON Card

[VesoTeam]

Hello,

i have updated a cisco 7204 router with a new ios 12.1(18) and cpa microcode (for ios 12.1) for an escon channel crad. After installing the software and code the router wouldn´t initilaize the escon card. By rebooting it the "enabled" led is going on and after a few seconds it´s going off. Can anybody help me?!

Thanks a lot

[mmellet]

I do not find any known bugs on this issue. I only suspect if you have met the resource requirements for this adapter. Check for the requirements at http://www.cisco.com/en/US/products/hw/modules/ps2033/products_configuration_guide_chapter09186a00801056f4.html.

You may also want enable the debugs and watch the console for any meaning diagnostic messages.