on the cisco 880 there is a single port for both aux and colsole access.
I am working for an ISP and we configure the aux port as an ASYNC proving ISDN backup to the customer in case the adsl fails.
The problem is when fo rthe very first time the customer is using the aux port to dial out th emodem assign the speed for that line so when afterwards
you connect the console cable to access the router you get metal characters.
I tried to change the speed through the rommon and use either hyper terminal or putty but still I am getting metal characters. The only option is to dialout and access the router through the modem or telnet.
Has anyone came across the same probelm and fixed that?
Hitless Authentication was introduced in Cisco DNA Center 126.96.36.199 providing the ability to modify the Authentication Template under "Host Onboarding" without the need to remove SGTs, VNs, and IP Pools and therefore avoi...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 188.8.131.52 as the RP for these groups:184.108.40.206/32220.127.116.11/3218.104.22.168/2422.214.171.124/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...