Can a pair of msfc's (both in the same box 6513) which has 6 vlans configured with HA (high available) have a new vlan turnup that is not configured for HA? And will the box run both non HA vlans along with HA vlan running at the same tme between the the two msfc's in the same box? I tried to turn up this type config but the msfc's could not snyc because the config are not the same on both. Is there a way around this?
! 1st msfc
redundancy
high-availability
config-sync
!
interface Vlan23
description VLAN23:
ip address x.x.x.4 255.255.252.0 alt ip address x.x.x.5 255.255.252.0
no ip redirects
standby 5 ip x.x.x.1
standby 5 priority 105 alt standby 5 priority 100
standby 5 preempt
!
interface Vlan27
description VLAN27:
ip address y.y.y.68 255.255.255.192 alt ip address y.y.y.69 255.255.255.192
no ip redirects
standby 11 ip y.y.y.65
standby 11 priority 105 alt standby 11 priority 100
standby 11 preempt
!
interface Vlan28
shutdown
description VLAN28:
ip address z.z.z.10 255.255.255.248
no ip redirects
!
end
==========
! 2nd msfc
redundancy
high-availability
config-sync
!
interface Vlan23
description VLAN23:
ip address x.x.x.4 255.255.252.0 alt ip address x.x.x.5 255.255.252.0
no ip redirects
standby 5 ip x.x.x.1
standby 5 priority 105 alt standby 5 priority 100
standby 5 preempt
!
interface Vlan27
description VLAN27:
ip address y.y.y.68 255.255.255.192 alt ip address y.y.y.69 255.255.255.192
no ip redirects
standby 11 ip y.y.y.65
standby 11 priority 105 alt standby 11 priority 100
standby 11 preempt
!
end