09-24-2001 07:57 PM - edited 03-01-2019 06:46 PM
I am trying to simulate a T1 link (not using DCE/DTE cable), by using a T1 CSU/DSU WIC on one router and on another router I am using an external third party CSU/DSU (Verilink). To simulate the service provider network, I connect the RJ45 cable between the two CSU network connection as follows
1-4
2-5
4-1
5-2
The line comes up, but the protocol doesn't??
Encapsulation on both serial port = hdlc
bandwith on both = 1544
WIC-T1 is line time, full rate T1, ESF/B8ZS
External CSU is internal timed, ful rate t1, ESF/B8ZS
09-27-2001 03:59 AM
but in this simulation, who is providing the clock for the circuit????...
ramesh
10-01-2001 06:03 AM
yeps, you should configure clock rate
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide