05-28-2015 01:43 PM - edited 03-03-2019 07:52 AM
I am consoled into a new switch, 3560, and when viewing the config, it does not give me the "more" option to display the next page. I have changed the term length to see if that helps, and it does change the number of lines displayed, but it never gives me the "more" option.
Thanks
05-28-2015 02:24 PM
Please post the complete output to the command "sh term".
05-28-2015 04:36 PM
this is sh term. I had set the term length to 400 so I could display the whole config.
Switch#sh term
Line 2, Location: "", Type: "LINUX"
Length: 400 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600
Status: PSI Enabled, Ready, Active, No Exit Banner, Automore On
Capabilities: Receives Logging Output
Modem state: Ready
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
00:10:00 never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is unknown.
Session limit is not set.
Time since activation: 00:00:37
Editing is enabled.
History is enabled, history size is 20.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed input transports are telnet ssh.
Allowed output transports are telnet ssh.
Preferred transport is telnet.
Shell: disabled
Shell trace: off
No output characters are padded
No special data dispatching characters
Switch#
Switch#
05-29-2015 10:45 AM
Thanks for looking. Issue was with SCRT. Someone messing with the settings.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide