cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

124
Views
0
Helpful
3
Replies
Highlighted
Beginner

console not showing the "more" option. Only displays one page according to term length command?

I am consoled into a new switch, 3560, and when viewing the config, it does not give me the "more" option to display the next page.  I have changed the term length to see if that helps, and it does change the number of lines displayed, but it never gives me the "more" option.

Thanks

3 REPLIES 3
Highlighted
Hall of Fame Community Legend

Please post the complete

Please post the complete output to the command "sh term".

Highlighted
Beginner

this is sh term.  I had set

this is sh term.  I had set the term length to 400 so I could display the whole config.

 

Switch#sh term
Line 2, Location: "", Type: "LINUX"
Length: 400 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600
Status: PSI Enabled, Ready, Active, No Exit Banner, Automore On
Capabilities: Receives Logging Output
Modem state: Ready
Special Chars: Escape  Hold  Stop  Start  Disconnect  Activation
                ^^x    none   -     -       none        
Timeouts:      Idle EXEC    Idle Session   Modem Answer  Session   Dispatch
               00:10:00        never                        none     not set
                            Idle Session Disconnect Warning
                              never
                            Login-sequence User Response
                             00:00:30
                            Autoselect Initial Wait
                              not set
Modem type is unknown.
Session limit is not set.
Time since activation: 00:00:37
Editing is enabled.
History is enabled, history size is 20.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed input transports are telnet ssh.
Allowed output transports are telnet ssh.
Preferred transport is telnet.
Shell: disabled
Shell trace: off
No output characters are padded
No special data dispatching characters
Switch#
Switch#

Highlighted
Beginner

Thanks for looking.  Issue

Thanks for looking.  Issue was with SCRT.  Someone messing with the settings.

 

Thanks