06-24-2006 06:28 PM - edited 03-03-2019 03:48 AM
I create Vlan 1, but see Vlan 1 is down.
#sh int vlan 1
Vlan1 is down, line protocol is down.
can someone explain the reason.
Thanks.
06-24-2006 07:03 PM
In order for your VLAN1 to show up/up one of the following two conditions should hold:
1) There should be one active (physically up) access port in VLAN 1.
2) VLAN1 should be carried in an active trunk on the switch (normally it is).
This is because of a feature called autostate which brings up the logical interface (vlan interface) up only when there is a physical device on that VLAN.
06-25-2006 02:43 AM
Hi. You need to connect atleast one port from switch to other device.
After that , you will get Vlan 1 ( Default) is up and operational.
-MM
11-13-2019 07:17 PM
click on the switch
click on the CLI tab
type in :
enable
configure terminal
int vlan 1
no shutdown
(enter)
,then it'll be all right
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: