cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
217
Views
0
Helpful
2
Replies
Highlighted
Beginner

Dell servers, VMware, Nexus 6Ks and vPC config support

Hello, we have some Dell R640 servers, each with two 10 Gb interfaces that we have connected to two Cico 6K (5600) switches in a vPC. We have installed VMware on them and there is an issue on the switch end on  the vPC with the show port-channel summary command showing that the links are in the Individual (I) state.

 

Is this a supported setup (Dell servers + Cisco vPC)? If it is then could the VMware NIC settings be causing the problem i.e. what aggregation mode should we be using?

 

Thanks for any help

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Engager

Re: Dell servers, VMware, Nexus 6Ks and vPC config support

 

 - Have a look at the advisories and video here :

              https://kb.vmware.com/s/article/1004048

 M.

View solution in original post

2 REPLIES 2
Highlighted
VIP Engager

Re: Dell servers, VMware, Nexus 6Ks and vPC config support

 

 - Have a look at the advisories and video here :

              https://kb.vmware.com/s/article/1004048

 M.

View solution in original post

Highlighted
Beginner

Re: Dell servers, VMware, Nexus 6Ks and vPC config support

Thanks for the info, we're just waiting for our network guys to configure the vPCs correctly and we'll set up the teaming as per the article.