Mainly, we use to began a work on interfacing to energywise other kind of objetcs than IT devices (Computer, Phones, Routers, ...) like (power sensor/actuators) . This work quite well with our specific PowerLine or Radio smartPlugs, or Din rails than can deliver their consumptions and that can be actuated to different power levels.
Now to go further we are asking ourselves where to discuss of next evolutions of energywise system.
I do not know if i'm at the right place to open this subject, so please do no hesitate to "re-direct" my post.
Current lu our main questions are about:
- Other kind of datatype recording like Temperature, Luminance, Presence, etc .. could be very useful for optimizing energy efficiency algorithms in softwares like Joulex, Orchestrator or other.
- IPv6 support for energywise
- Other kind of transport protocol like (CoAP) for constrained objects.
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...