09-23-2019 10:36 AM
Hello,
I am using router ISR C1111 8p. I have option to make port-channel and assign IP to it, but when i have to configure channel group on interfaces i am not able to run command "Channel-group 1 mode active". error message Unrecognized command.kindly suggest any solution to this problem
Regards;
Khushbakhat
09-23-2019 10:50 AM
Hello
What options do you receive?
in x/x
Channel-group ?
Channel-group 1 ?
09-23-2019 11:34 PM
09-24-2019 02:33 AM
Dear Leo ;
Thanks for your concern, kindly share any data sheet in which it is listed that ISR C1100 series not supported Ether-channel.
Regards:
Khushbakhat.
09-24-2019 03:20 AM
09-24-2019 10:07 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide