cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

206
Views
0
Helpful
5
Replies

Etherchannel

Hello,

 

I am using router ISR C1111 8p. I have option to make port-channel and assign IP to it, but when i have to configure channel group on interfaces i am not able to run command "Channel-group 1 mode active". error message Unrecognized command.kindly suggest any solution to this problem

 

Regards;

Khushbakhat

 

5 REPLIES 5
VIP Advisor

Re: Etherchannel

Hello

What options do you receive?
in x/x
Channel-group ?
Channel-group 1 ?



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
Hall of Fame Community Legend

Re: Etherchannel

c1100 doesn't support EtherChannel.
The router is "too small".

Re: Etherchannel

Dear Leo ;

 

Thanks for your concern, kindly share any data sheet in which it is listed that ISR  C1100 series not supported Ether-channel.

 

Regards:

 

Khushbakhat.

 

Hall of Fame Community Legend

Re: Etherchannel

Read the Data Sheet (LINK).  Notice the word "etherchannel" is absent? 

Have you read the Release Notes for the 1100 router (LINK)?  Same thing, the word "etherchannel" is not mentioned.  

Don't believe me?  Raise a TAC Case or contact your Cisco AM/SE/PSS.

VIP Expert

Re: Etherchannel

Some older ISRs, if they supported Etherchannel at all, only supported the manual variant.
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards