12-11-2002 02:03 PM - edited 03-02-2019 03:32 AM
Hello. I have a frame-relay map-class set up on my DLCI for 128K but when I run the command show traffic-shape it shows that the target rate is 56000 what would be causing this?
Thanks
Will
12-17-2002 02:56 PM
Not enough information to answer this question, refer the following URL and verify your configuration
12-25-2002 08:02 PM
Check your naming convention for the map class
The map and the class names must match
The map class name possibly doesn't exist that you are using under the sub-interface
note: the map -class name is case sensitive
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide