I only realize Sup720-3B have the limitation of 235K route where full table now is near to 500k route. I need you guy help to answer some of question in my mind.
1) What will happen if I use Sup720-3B as my BGP router with full routing table. Will it hang or make use of CPU resources to handle the route?
2) What will happen if I use Sup2u as my BGP router with full routing table. Will it hang or make use of CPU resources to handle the route?
3) If the answer to the above is CPU resources handle the route, will it work with my bandwidth usage? I am currently have 1 up stream 50Mbps. I plan to increase my bandwidth to 2 up stream with both100Mbps.
4) I have a C7200 G1 with 1GB RAM. Will this work better in my network?
Purpose of the documentReference TopologyUse-CaseSymptomDiagnosisSolutionAdditional References
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The ...
Dear All, When I use the show interface command on the Cisco Router ISR-4331, it will display as below information. The word that I mark red, it refresh every 5 seconds. But, I compare with the old router model like a Cisco 29XX or 28X...
Whether you're attending VMworld 2019 on-site or from afar, read the latest on the key themes to expect. They are also the key themes for IT management today, from software defined everything to cloud and automation to IoT and edgecomputing : http:...
To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about SD-WAN), it's foundations and inner mechanisms as well as its correct design a...