Half duplex on WS-X6516-GE-TX line card

[ackyean]

Hi,

I wish to know if the WS-X6516-GE-TX line card can support half duplex command.

Aaron

[Prashanth Krishnappa]

No.. All ports on this card are 1000Base Full duplex.

[ackyean]

Hi,

"No.. All ports on this card are 1000Base Full duplex."

Am I right to say that this card can only support either 10-full, 100-full and 1000-full duplex only?

Therefore, I will not be able to configure 100-half or even 1000-half duplex right?

Thanks

[Mark Turpin]

http://www.cisco.com/en/US/products/hw/switches/ps708/products_command_reference_chapter09186a008022f4b8.html#wp1239856

If the transmission speed on a 16-port RJ-45 Gigabit Ethernet port is set to 1000, duplex mode is set to full. If the transmission speed is changed to 10 or 100, the duplex mode stays at full. You must configure the correct duplex mode when transmission speed is changed to 10 or 100 from 1000.

Hope this helps,

Mark Turpin

[Prashanth Krishnappa]

Actually, I stand corrected. This card is a 10/100/1000 Base T card and can support half duplex as well.

Here is an output of sh port capability

Model WS-X6516-GE-TX

Port 3/1

Type 10/100/1000

Speed auto,10,100,1000

Duplex half,full

Trunk encap type 802.1Q,ISL

Trunk mode on,off,desirable,auto,nonegotiate

Channel yes

Broadcast suppression percentage(0-100)

Flow control receive-(off,on,desired),send-(off,on,desired)

Security yes

Dot1x yes

Membership static,dynamic

Fast start yes

QOS scheduling rx-(1p1q4t),tx-(1p2q2t)

CoS rewrite yes

ToS rewrite DSCP

UDLD yes

Inline power no

AuxiliaryVlan 1..1000,1025..4094,untagged,dot1p,none

SPAN source,destination

COPS port group 3/1-4

Link debounce timer yes