cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
242
Views
0
Helpful
1
Replies

Help in switch port analysis

msaifulla
Level 1
Level 1

Greetings!

I am new to Switch monitoring. I have setup span in a 2900 cisco switch. The actual command i used is: "set span 2/1 3/25". But it is not giving the full traffic. Am i missing out anything?

Thanks and Regards,

Saifullah

1 Reply 1

Hello,

try this:

Switch> (enable) set span 2/1 3/25 both

Switch> (enable) set span enable

Although 'both' is the default when nothing is specified, check if explicitly stating it gives your more traffic to monitor.

Regards,

GP

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: