Attempting to configure VxLAN EVPN on a pair of Catalyst 9500-32C's for a Proof of concept. No joy so far. Been referencing these links:
Main goal is to bridge a single VLAN and have 2 hosts communicate across the VTEPs.
Official answer we received from Cisco was that at this time the 9k is not supported in the Spine function. We have put in a feature request for this role and are awaiting and *hoping* for support in a future release. If you put in a feature request as well this may help...;)
Would you mind sharing your config on those two switches?
Please find attached the config of one device the second is also similar,
Please let me know if you still have issues
Here also attached tested configs for 2 leaf switches.
My goal was just to do a POC for extending the VLAN across an IP network using EVPN on C9500.
The switches are directly connected but you can easily amend the BGP for multihop.
I hope that helps.
I just wanted to know about 10.0.41.1 and 10.0.41.252 IPs in your configs configured as BGP neighbor IPs. Are these the layer-3 interfaces connecting both the switches?