Help with CMTS/DOCSIS config. Cable Modems not going into Dual IP mode.
I am trying to get a Ubee modem to go into Dual-IP mode. The CMTS is already configured and I have a DOCSIS file uploaded to the CMs that work. They are online and registered with DHCP ipv4 addresses.
I have been reading and following the IPV6 on Cable guide from Cisco and I have already configured the CMTS and enabled TLV 202 & TLV 202.1 (Dual IP Mode) on the DOCSIS file, yet a "show cable modem verbose" shows Dual-IP:N no matter what I do. Also note a "show ipv6 neighbors" does show the CM so I know ipv6 is working, it's just that the CM does not go into Dual-IP mode. I have attached the CMTS backup. Any help is appreciated.
Webcast event: Catalyst 9000 Series: Best Practices and New Troubleshooting Features
This special event is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are accessible only to Cisco customers, partners, or logged...
This Document shows how we can set up 2 Factor authentication using RSA SecurID token with one time token based on a PIN to login to the Cisco DNAC Web interface.
Two factor authentication provides two or more authentication factors...
Hi Cisco Team.I have issue with Catalyst 4500 device, it is automatin reboot while use.I sent to team some information this device Version: Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK...
The network is growing and how! Data is being generated at such an exponential rate. An IDC report states that data will grow to 175 Zettabytes by 2025. With such an explosion, enterprises cannot keep sending all the incoming data directly to the cloud. T...
%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/6: Power given, but Power Controller does not report Power Good we are getting this error after we upgrade our ios from 12.2(55)SE to 152-2.E9 on the 2960s ( WS-C2960S-48LPS-...