05-13-2004 12:22 PM - edited 03-02-2019 03:42 PM
05-13-2004 08:03 PM
There isn't a specific debug but you can use the LOG parameter on the access-list statements to log matches which might help.
05-13-2004 09:46 PM
One could also turn the debug at the ACL level via
[no] debug ip packet [access-list-number] [detail] [dump]
However, this is supported only for numbered ACLs. You may want to refer to http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_command_reference_chapter09186a00801a7e88.html#wp1086651
Thanks,
Rajesh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: