How to enable egress traffic in Netflow

[kjr_78901]

Hi guys

I  trying to figure out how to enable egress traffic in a icmp flow

Here the scenario, 2 routers

     Fa0/0                                                                                                          Fa0/0 

RA ------------------------------------------------------------------- RB

10.0.0.1/24                                                                                                    10.0.0.2/24

In RB

int fa0/0

 ip add 10.0.0.2 255.255.255.0

 ip flow ingress

 ip flow egress

When I ping from RA to 10.0.0.2 (RB), the source is 10.0.0.1 in the show ip cache flow in RB I can see the incoming traffic, but not the echo reply (If a put a wireshark in the link, I track the echo replys).

So How I can enable RB to show me the egress traffic?

[Diana Karolina Rojas]

Hello! good evening!

What IOS version are you using in your router? The support for accounting in the egress traffic is only supported in 12.3(11)T IOS or higher. This is a link for your reference: https://www.cisco.com/en/US/docs/ios/12_3t/netflow/command/reference/nfl_a1gt_ps5207_TSD_Products_Command_Reference_Chapter.html#wp1187159

Please do not forget to rate useful post.

Best Regards,