11-19-2003 12:41 AM - edited 03-02-2019 11:49 AM
hi,
I have a 3550 switch with ZX and configure UDLD.
When I pull out single line, the port will be down in 50 sec. Could I reduce the time ?
best regards.
fred.
11-25-2003 09:17 AM
Hi Fred,
I am afraid we cannot reduce this becuase the Spanning Tree Calculations take place during that time.
11-25-2003 12:51 PM
try UDLD aggressive mode.
11-26-2003 06:09 AM
It sounds like you don't have autonegotiation active or the port would immediately go down when you pull out a single line. The first thing I would suggest is configuring autonegotiation but it you can not do that you can adjust the udld timer with, udld message time N.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: