cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

218
Views
5
Helpful
5
Replies
Highlighted
Beginner

I can't ping the server or access the domain (NAT configuration)

Hello community,

 

Who can help me?

In this lab on packet tracer, in cant ping from pc0 and pc1 to the Server or the domain.

What i configured wrong?

 

Nat.pngNAT1.pngNAT2.pngNAT3.pngNAT4.png

 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Advisor

Re: I can't ping the server or access the domain (NAT configuration)

Hi @Mailson 

 

With the show interfaces command, you can verify that the fa0/1 interface is not obtaining DHCP addressing.

This is because the cloud settings are incorrect.

To correct this, make these changes:

Go to the cloud> configuration> Ethernet6 and switch to the cable:

12.jpg

 

Then go to cloud> configuration> Cable and press Add to add the connection between these interfaces:

123.jpg

 

After these changes, the fa0/1 interface gains DHCP addressing and connectivity is successful.


Regards

View solution in original post

5 REPLIES 5
Highlighted
VIP Advisor

Re: I can't ping the server or access the domain (NAT configuration)

Hi @Mailson 

 

I notice that you are missing a default route.
This is necessary for the router to have a route to unknown networks (internet).


Try this:
 Router(config)# ip route 0.0.0.0 0.0.0.0 fa0/1

 

Regards

Highlighted
Collaborator

Re: I can't ping the server or access the domain (NAT configuration)


You could attach PT file here if you need further help
Highlighted
Beginner

Re: I can't ping the server or access the domain (NAT configuration)

Hi Martin,

 

Here the file PKT

Highlighted
VIP Advisor

Re: I can't ping the server or access the domain (NAT configuration)

Hi @Mailson 

 

With the show interfaces command, you can verify that the fa0/1 interface is not obtaining DHCP addressing.

This is because the cloud settings are incorrect.

To correct this, make these changes:

Go to the cloud> configuration> Ethernet6 and switch to the cable:

12.jpg

 

Then go to cloud> configuration> Cable and press Add to add the connection between these interfaces:

123.jpg

 

After these changes, the fa0/1 interface gains DHCP addressing and connectivity is successful.


Regards

View solution in original post

Highlighted
Beginner

Re: I can't ping the server or access the domain (NAT configuration)

U are the best

Thank you again

problem solved!