interface showing “Link not connected” on a Nexus 2200 FEX but it is very much connected
I have to be over looking something dumb here but I can't figure it out.
The fex is set up properly and is communicating to the Nexus 5548 without issue. There are a few other fexs connected as well.
The interface is a bare bones at this point:
switchport access vlan xx
spanning-tree port type edge
I have tried to plug other devices into the port and no link lights will come up. No errors are shown in the log. I have connected to the server via its Ethernet port from a directly connected laptop and its link lights come up no problem.
The vlan is already on the switch as well.
A show interface shows that zero traffic has crossed the link.
If there is any other information I could provide please let me know.
Do you use Cisco DNA Center? Have you used and are you willing to provide your feedback in using the Cisco DNA Center help and documentation?
If so, we’d like you to complete the survey linked below. Your feedback will help provide more effective and easi...
Listen: https://smarturl.it/CCRS9E18Follow us: https://twitter.com/CiscoChampion Reaching the height of your career is no simple feat. It often requires a combination of pursuing the right education, building the right professional network and being ...
In a typical production SD-WAN deployment, we would probably have many remote sites connected via many different Internet connections to a centralized data center or a regional hub. In most regions in the world, Internet providers will always use some typ...