I am stumped by some sort of routing problem. Any assistance is appreciated!
I have several Meraki Cameras in a remote site that are currently in VLAN 1.
I need to move the cameras into a dedicated VLAN (VLAN 300).
When I move a camera into VLAN 300 I can no longer reach the Meraki Cloud servers.
My ASA is NOT blocking traffic.
I can ping the camera from the "master site".Meraki
From the remote site Switch 2 (where the camera is plugged in) I can ping Meraki Cloud Server as long as I source the ping from VLAN 1. When I source the ping from VLAN 300, it fails.
Here are the routing snippets from my routers / switches:
ip route 0.0.0.0 0.0.0.0 172.17.0.14 ip route 10.1.0.0 255.255.254.0 10.255.255.2 ip route 10.1.3.0 255.255.255.0 10.1.1.1 3 ip route 18.104.22.168 255.255.255.248 10.100.200.12 ip route 22.214.171.124 255.255.255.248 10.255.255.2
ip default-gateway 10.255.255.1 ip forward-protocol nd no ip http server no ip http secure-server ip tftp source-interface GigabitEthernet0/0/0 ip route 0.0.0.0 0.0.0.0 10.255.255.1 ip route 10.1.3.0 255.255.255.0 10.1.1.2 ip route 126.96.36.199 255.255.255.0 188.8.131.52
ip default-gateway 10.255.255.1 ip classless ip route 0.0.0.0 0.0.0.0 10.1.1.1
Cisco recently announced availability of the latest release on the IOS-XE train – IOS-XE Gibraltar 17.4.1. This is a standard maintenance release supporting Switching, Wireless, SP-Access, Routing as well as IOT platforms with a sustaining support lifetim...
The primary purpose of a switch is to make forwarding decisions based on destination MAC address. The MAC address table is created with a list of destination MAC address for each connected device. In addition the switch port assigned and VLAN member...
Cisco Nexus 1000V cloud switch is a virtual appliance. It provides integration of physical and virtualized network infrastructure. Cisco Nexus 1000V switch is compatible with VMware ESX and vSphere (ESXi) hypervisors. There is a version for Microsoft Hype...
Selecting the proper lab training platform is fundamental to preparing for CCNA certification. Cisco CCNA is a foundational networking certification that requires knowledge of IOS configuration of multiple protocols. So where do you start and what lab tra...
(view in My Videos)
“Use Serviceability Features to Troubleshoot your Cat9K as a Cisco TAC Engineer”
This event took place on Tuesday 1st, December 2020 at 10hrs PDT
This event provides an introduction to the main Cat9K serviceability features. Serv...