I am trying to figure out why the SLA is flapping between 10.1.2.2 and 10.1.3.2 every 15 seconds. The delay is below 60 Milliseconds and it still flaps to 2nd static route 10.1.3.2. Also, even if I shut down the interface on R2 , 10.1.2.2 still shows up in the routing table during the consistent flapping. I do have EIGRP configured as well. But I would think that the static entries would take precedence over the dynamic route since it has a lower AD. Here is the SLA configuration I have !
ip sla 1
icmp-echo 10.1.6.2 source-ip 10.1.1.1
track 1 ip sla 1
delay down 5 up 5
ip sla schedule 1 life forever start-time now
ip route 10.1.6.0 255.255.255.0 10.1.2.2 track 1
ip route 10.1.6.0 255.255.255.0 10.1.3.2 2
However I am getting this response even if the connection to router 2 to is down.
Router(config)# *Jan 2 17:00:03.150: %TRACK-6-STATE: 1 ip sla 1 state Down -> Up
Router(config)# *Jan 2 17:00:18.158: %TRACK-6-STATE: 1 ip sla 1 state Up -> Down
Router(config)# *Jan 2 17:00:33.166: %TRACK-6-STATE: 1 ip sla 1 state Down -> Up
Router(config)# *Jan 2 17:00:48.176: %TRACK-6-STATE: 1 ip sla 1 state Up -> Down
Router(config)# *Jan 2 17:01:03.180: %TRACK-6-STATE: 1 ip sla 1 state Down -> Up
Re: IP SLA flapping using ICMP delay within GNS3 LAB
Try changing the sla destination to the 10.1.4.2, as in that case any reachabilty issue to that destination will lose connectivity to 10.1.6.2 on that route path only, Because as it stands currently the ip sla is seeing 10.1.6.2 via its alternative route path as being up so sla transitions up again because thr ip sla source/destination is reachable, then the cycle continues.....
kind regards Paul
Please don't forget to rate any posts that have been helpful.
Let's clarify Spanning Tree Protocol, because it can be confusing.
I’m going to make this as painless as possible in the short beginning of this post, but details will follow for the rest that are curious in nature.
DOMINO168.NET BANDAR JUDI POKER ONLINE TERPERCAYA DI INDONESIADomino168.net merupakan situs agen bandarq, bandarkiu, agen bandarq, bandar66, bandar qq online terbaik,agen judi domino terpercaya. Connection alternatif bandarq, Daftar bandarkiu online terpe...
i have one switch and two ports for two dirrent network they is ring both port in same vlan configuration, i want solution if one port down then autometic traafic gone from 2nd port it is possible? Note: switch1 in 2 ethernet port avaibal...
How to upgrade Cisco IOS from Serial Port
In this topic, i will show how to upgrade Cisco IOS from the Serial Port using a console cable and Hyper Terminal without network connectivity (that would be needed for TFTP, in example). We will be using a 2960X...