IPX routing

[nawas]

We currently have a T1 connected to one of our remote site via Switch-32 (with MSFC) and I'm running RIP ver 2 on both ends. I'm

goig trunk another switch called switch-44 on switch-32 (with MSFC) and turn up the DS3

circuit while T1 remain in place on sw-32. I have IP and IPX running. I know I can handle IP traffic via offset list, what will happen to my IPX traffic when I will have two path. How will I control my traffic? How can I direct IPX to be a preffered path over DS3 and not on T1. Please help.

[rfroom]

I would suggest running IPX EIGRP over the DS3 and T1 to save bandwidth.

You can adjust the delay value to force IPX over the preferred path.

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080f2b.html#28293