I would like to be able to issue snmpset and snmpget commands to a particular device from my router.This must be done using SNMP V3
snmpset -v 3 -u <user> -l authPriv -A <auth> -X <priv> -a SHA -x AES <host IP> <OID>
Does anyone know if this is possible?
on a 7600/SRE4 I do see such a possibility:
7600#snmp get ?
v1 use the SNMPv1 protocol
v2c use the SNMPv2c protocol
v3 use the SNMPv3 protocol
7600#snmp get v3 ?
WORD IP/IPv6 address or hostname of SNMP destination
7600#snmp get v3
That is very interesting, thanks. I had been told by Cisco that it was not possible and that there were no plans to introduce it!
I will look further into this.....