Hi to All,
I have an error when complete the wizard . installation failure decision to exit
why? anyone have an idea?
if I try to type the command
interface VirtualPortGroup31 this command is not present in my router. I think who is this the error but how does to resolve it?
thanks a lot for support
below some informations
System image file is "bootflash:isr4300-universalk9.16.03.06.SPA.bin"
Suite License Information for Module:'esg'
--------------------------------------------------------------------------------
Suite Suite Current Type Suite Next reboot
--------------------------------------------------------------------------------
FoundationSuiteK9 FoundationSuiteK9 RightToUse FoundationSuiteK9
securityk9
appxk9
AdvUCSuiteK9 None None None
uck9
cme-srst
cube
Technology Package License Information:
-----------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
------------------------------------------------------------------
appxk9 None None None
uck9 None None None
securityk9 None None securityk9
ipbase ipbasek9 Permanent ipbasek9
cisco ISR4321/K9 (1RU) processor with 1650898K/6147K bytes of memory.
Processor board ID FLM2107W139
2 Gigabit Ethernet interfaces
32768K bytes of non-volatile configuration memory.
4194304K bytes of physical memory.
3223551K bytes of flash memory at bootflash:.
20971520K bytes of SATA hard disk at harddisk:.
0K bytes of at webui:.
Configuration register is 0x2102
xxxxxxxxx#sh license feature
Feature name Enforcement Evaluation Subscription Enabled RightToUse
appxk9 yes yes no yes yes
uck9 yes yes no no yes
securityk9 yes yes no yes yes
ipbasek9 no no no yes no
FoundationSuiteK9 yes yes no yes yes
AdvUCSuiteK9 yes yes no no yes
cme-srst yes yes no no yes
hseck9 yes no no no no
throughput yes yes no no yes
internal_service yes no no no no
