cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

3764
Views
0
Helpful
2
Replies
Highlighted
Beginner

Jitter, delay, packet loss - Cisco and Juniper

Hi guys.

I am about to support a new customer which has two sites. There is a cisco router in one site and a juniper in the other site.

I am used to monitor Delay, jitter and packet loss when using Cisco equipments.

I am not used to juniper... is that possible, somehow, to configure an IP SLA between the Cisco and Juniper equipments? If so, how could I do this?

Thanks in advance

2 REPLIES 2
Participant

Jitter, delay, packet loss - Cisco and Juniper

Beginner

Jitter, delay, packet loss - Cisco and Juniper

Hi Amrinder.

Thanks for replying.

With Cisco equipments, I am used to configure one side as monitor and another as responder. My concern is related to Cisco being the monitor and juniper as a responder, how can I configure it as a responder (if that´s possible).

I had checked for that documentation few days ago, but my concern isto know if this will work between a cisco and juniper equipments. According to I see, Juniper just generates traffic and waits for an answer in order to analyze and compute results, which is fine, but the opposite (from cisco to Juniper), I don´t know since I use the monitor and responder.

thanks

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here