cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1895
Views
0
Helpful
0
Replies

Keepalive and Timeout configuration on PPPoE (ASR 9010)

emer-nmf
Level 1
Level 1

In a situation where the router is running 20k subscribers, what would be the better config of Keepalive and Timeout on my dynamic-template? 

 

Today I'm running only keepalive with a interval of 60 seconds and 20 retries to end the session. I'm thinking about the idea of using both of them, but not sure about it.

 

Example of my configuration below:


dynamic-template
type ppp PPP_BASE_TPL
ppp authentication pap chap
keepalive 60 20
ppp ipcp dns 192.168.0.1 192.168.0.2
ppp ipcp peer-address pool PPPOE
accounting aaa list default type session periodic-interval 1       (that interval also doesn't seem right)
ipv4 unnumbered Loopback10
ipv6 enable
dhcpv6 address-pool V6
dhcpv6 delegated-prefix-pool V6-LAN
ipv4 access-group REDIRECT ingress

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: