06-01-2003 05:36 PM - edited 03-02-2019 07:47 AM
I got follow message on C7206VXR with NPE-G1 processing egine.
"Multicast distributed switching is not allowed on tunnel interfaces"
I can find this message when I show running-config, or write memory.
How can I remove this message, and Why I got this message?
there are no mroute-cache or ip multicast command
and 'cause this is C7206, No distributed option on mroute-cache.
what's the problem?
06-01-2003 06:11 PM
May be if you can provide a snapshot of your config, with passwords and ip addresses masked, for further troubleshooting...
06-01-2003 06:19 PM
I Got this message on Default configuration.
Means When I first boot up this device, I got this message.
Diags are following
- 7206VXR/NPE-G1 7206VXR with NPE-G1 processing engine
- MEM-NPE-G1-512MB Two 256MB mem modules (512MB total) for NPE-G1 in 7200
- MEM-NPE-G1-FLD128 Cisco 7200 Compact Flash Disk for NPE-G1, 128 MB Option
- C7200-I/O Cisco 7200 Input/Output Controller
- MEM-I/O-FLD128M Cisco 7200 I/O PCMCIA Flash Disk, 128 MB Option
- PA-2T3+ 2 Port T3 Serial Port Adapter Enhanced
- PA-8T-V35 8-Port Serial, V.35 Port Adapter
- PWR-7200-ACE= Cisco 7200 AC Power Supply With European Cord
- MAS-7200-CBLMGMT Cisco NPE-G1 Cable Management Bracket
no further configuration on it.
06-01-2003 11:05 PM
It was a BUG.
ID is CSCdz25306.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: