06-28-2004 06:54 AM - edited 03-02-2019 04:40 PM
NAM2 with 3.3(1) & Patch 1 (maintenance 2.1(1)) in a 6500 13 slot (IOS 12.1(19)E1a.)
Recently installed. On a SPAN port (to a device, or Trunk to another switch) it monitors Tx, but says there is no RX traffic. On an Etherchannel, it monitors both directions.
Any suggestions/ideas?
(it was doing this with NAM2 v3.1, so I upgraded it to 3.3)
06-28-2004 09:31 AM
Have you spanned the source in both directions?. Does this happen for every span source?
06-29-2004 01:03 AM
Tried it with Both directions onto one NAM interface. Traffic looked wrong. Tried TX onto one NAM interface & RX to the other. Traffic only registered on TX.
Tried reversing Tx and RX to opposite NAM interfaces. No difference.
Tried a couple of different source ports with devices (therefore only belong to one VLAN). Same thing.
Tried a Trunk Port (all VLANs, to another switch). Same thing.
Tried a Etherchannel (6 ports bonded, to another 6513. All VLANs). Traffic registered for both TX and RX.
It SEEMS to be the SPAN that does not work, rather than the NAM.
06-29-2004 10:16 AM
Then this is not a problem with the NAM itself.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: