cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Ask the Expert- SD-WAN

278
Views
0
Helpful
1
Replies
Beginner

NAT/PAT Configuration

I am configuring a routers, and would like to do nat overloading (pat). Is it possible to configure this with only a single outside address ?

Thanks in advance.

1 REPLY 1
Highlighted
Enthusiast

Re: NAT/PAT Configuration

Yes it is possible. You can do PAT either on an address you define in a pool or on an interface address.

ip nat inside source list pool test overload

OR

ip nat inside source list interface Fastethernet0 overload

Where is a standard or extended access-list you have configured. You can also use route-maps instead of lists to classify which packets to NAT/PAT.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards