Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
242
Views
0
Helpful
1
Replies

ODR routing and ping

polaris
Level 1
Level 1

‎08-22-2002 11:32 AM - edited ‎03-02-2019 12:51 AM

using 1 3640 as the hub router; multiple 2610 routers as the spoke routers. running ODR on the hub and a static default route (0.0.0.0 0.0.0.0 ser0/0) on the spoke routers. Also using IP unnumbered on the 3640 WAN ports with them referencing the IP address of the eth0/0 port. I can ping across the WAN host to host but I can't ping the hub router from the spoke routers. Is it because of the IP unnumbered or what? Any help would be greatly appreciated.

Labels:
0 Helpful
1 Reply 1

murabi
Level 4
Level 4

‎09-03-2002 01:36 PM

You'll probably need to debug icmp to see if the packets are ariving at the destination routers but before that, try doing an extended ping sourcing off a valid router IP address.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents