04-17-2005 07:53 AM - edited 03-02-2019 10:29 PM
I have got router 2600 , I tried to access the router with default hyper terminal setting , but I could not, then I changed the baud rate of (com1 properties) from 9600 to 19200.
It worked fine and I was able to be in usermode level of the router, when I tried to access the privilege, I could not,because the password has been changed.
I tried to recover the password by changing registration value, then I have to issue command reset,after "confreg 0x2102" command, to restart the router, but I received this funny character
rommon1>confreg 0x2102
rommon 2 > reset
ææøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøø
øøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøøø
øøøøøøøøøøøøøøøøøøø
what should I do to solve this issue
04-17-2005 08:48 AM
Two things.
First, the value to use for the password recovery is 0x2142.
Second, try resetting the HyperTerminal speed back to 9600 after the reset.
Hope this helps,
04-17-2005 10:37 AM
Hello,
to be on the safe side, I would also install the latest version of Hyperterminal, you can download it here:
HyperTerminal Private Edition version 6.3
http://www.hilgraeve.com/htpe/
Regards,
GP
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: