Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
246
Views
0
Helpful
1
Replies

Port adapter question for 7206VXR

mitchel
Level 1
Level 1

‎02-14-2002 05:37 PM - edited ‎03-01-2019 08:29 PM

I have a 7206VXR with a Multichanel T-1 port adapter, PA-MC-2T1. Can I use this for my T-1's to my upstream bandwidth providers? It has built in CSU/DSU so I'm thinking I can. Also when I boot up the router I cannot see the interfaces, the ports show up during boot but a sh int does not see it. This port adapter has never been configured on this router.Running Version 12.0(10)S currently, router is not online yet.

Labels:
0 Helpful
1 Reply 1

tepatel
Cisco Employee
Cisco Employee

‎02-14-2002 08:20 PM

PA-MC-2T1 is two port channelized T1 PA.So in the config will not be listed as "interfaces" but it will be appeared as a "controller t1 x". Since you have 12.0.10S then the router should recognized it.

To configure that PA you can visit following url

http://www.cisco.com/univercd/cc/td/doc/product/software/ios111/cc111/pamce1t1.htm

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents