POS terminal calls to Access server mapping to X25 addresses

[mustafa.mail]

Hi,

Can some one help me with the configuration required on the Access Server for the following setup:

POS terminals will call the access server using a PRI ISDN E1. Then the Access Server in turn will answer and process the calls. The required scenario is to encapsulate the ASYNC traffic generated from the POS terminals into X.25 protocol and addresses. The AS has to answer incoming calls and map them into X.25 addresses. Mapping between the incoming calls and X.25 addresses is required.

Regards,

Banno

[makchitale]

I assume the setup is something like the below:

POS---async ISDN E1--AS---X25---host

Config:

line x y

autocommand pad

!

x25 routing

!

x25 route interface serial x/y

!

int ser x/y

encap x25

Thanks, Mak.