05-26-2004 12:43 AM - edited 03-02-2019 03:56 PM
Ey there.
I have a few cisco 800 series routers. And i want to set up a priority list.
I want to give HTML traffic a higher priority then telnet traffic (over IP)
When i go to the priority list command, then i go to IP, i can just change the priority of the IP protocol, but i want to adjust the priority of the HTML and telnet traffic.
How can i do this?
05-26-2004 01:32 AM
Are you looking for this ?
priority-list 1 protocol ip high tcp 80
priority-list 1 protocol ip medium tcp 23
HTH
05-26-2004 01:56 AM
If the rotuer is ADSL( 826, 827, 836, 837) you can't configure priority-list and you will be configure CBWFQ.
If the router is 805 put in interface serial0
priority-list 1
and before configure that you say "jolmo"
Best Regards
05-26-2004 02:08 AM
Jolmo? what's that?
I check a 2500 router and i works! But the prob is, the real router that i have to configure is a 827!
What do i need to do, to let it work on that? (everything is connected on the eth0)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: