05-10-2012 12:49 PM - edited 03-03-2019 06:34 AM
Hi,
I bought a CCNA lab for doing practice.
The lab kit is made of some 2600XM routers.
These routers have only one "fast ethernet port 0/0".
I don't understand how I can configure these routers whith: Static Routing, Defoulte Route etc etc if I have only one "fast ethernet port 0/0" and I don't have the "0/1 port" too.
Any help is much appreciated.
Thanks.
Massimo
05-10-2012 07:11 PM
You can, for example, connect to a switch with vlan taggin, and use subinterfaces.
Or use some simulator that allows multiple interfaces.
05-11-2012 01:11 AM
Thank you very much for your answer,
Please can you tell me the name of one "simulatotor", or do one example of vlan tagging; I don't have much experience..........because I used only router with 0/0 and 0/1 ports.
thank very much in advance for your help.
Massimo
05-11-2012 11:22 AM
Search GNS3 or "vlan subinterface".
05-11-2012 01:45 PM
I'll search it.
For now thank you very much for your inputs . "grazie".
Massimo
05-11-2012 10:06 PM
You're welcome, please remember to rate useful posts clicking on the stars below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: